Reloop RP8000

Description and Instructions

Self explanatory except for my user set which from the bottom up is:
Absolute Mode, Relative, Internal, Low Kill, Mid Kill, High Kill, Keylock on/off, Sync on/off.

Also holding and turning the encoder gets you through trees and turning it normally browses the current list.

Enjoy!
Problem downloading or other issues? Let us know on the forum.
-
Comments for v0.1.0
Fischer van Gulden almost 10 years ago
Great mapping, Thank you for sharing!! Only one issue for me, On deck 2 Tree Browsing is not working properly. any suggestions on how i can fix that? I tried adjusting the parameters in the Controler Editor, no luck.
Buggles almost 10 years ago

I'll give it a go tonight and see if I can post a fix for tomorrow.

Joshua Schaffer almost 10 years ago
Thanks for the mapping. I want these turntables but was wondering if they worked with traktor. Do you still need an interface between the turntable and traktor or can you just plug them right into the laptop??
Buggles almost 10 years ago

You plug one RP8000 USB into the other RP8000 and then into the laptop, so it only takes up one port on your laptop. However you'll still need an NI sound card or Z2 to enable scratch control. I've been happily mixing with nothing but my old analog mixer, my laptop and two RP8000's and the pitch control is like butter! No center indent, extremely low flutter and a digital readout make beatmatching more enjoyable than ever before (especially since the resolution is in .02% steps). Better than Technics IMHO. With my mapping I've basically replaced my s4's transport with a needle and record and from there I can easily switch from absolute to relative or even internal modes. Highly recommended!