Hello! Can somebody how i can put together Mixer + Pad. Not only Mixer or Pad by oneself? Thanks for answer!

when touching the top surface of the jog wheel, i expect it to stop, like a vinyl. but it doesnt, and idk how to make it do that

Hey Michael, thank you very much for the mapping. I scratched my head quite a bit over the Pad Mode button MIDI output. Looking at your mapping, I realized that it outputs on 2 MIDI channels: both of the buttons output on MIDI Ch. 16 Note 50, but also on Ch. 5 and 6 respectively, either Note 0, 14, 11 or 15, depending on the state of the Mode LED (Hot Cue, Loop, Sample, Effect). Only with the Ch. 5 and 6 outputs it is possible to set the modifier states in Traktor 3 just as you did. Also on another topic: I'm unsure if it is neccesary to set certain buttons and knobs to their software counterpart in Traktor while using the PartyMix2 not only as a MIDI controller but also as an audio device: e.g. the Main volume knob does also control the volume of the main out jack on the left side of the controller. So in this scenario it would maybe be better to turn the mapping for this knob off? This is also the case with the Headphone volume control and both Cue select buttons. Of course if you use the PartyMix2 only as a MIDI controller and you have a seperate audio device to output sound, then mapping the controls makes total sense.

hello, how about the headphone monitor buttons and the bpm faders